top of page
SAMOPRINT
instruction
before you start
WARNINGS:
· kids under the age of 12 must do their printing sessions only under careful supervision of adults
· if you have been burned by an iron, we recommend that you consult a doctor
· always make sure the the stickers are arranged with the right side facing up, otherwise they can stick and potentially damage the iron surface
· if a sticker was placed the wrong side up and got stuck to the iron, turn off the iron, unplug it from the electrical source and use the special iron cleaner to clean up your iron before you can continue printing
REMEMBER:
· always put the protective cloth over the stickers when using the iron
· always take off the transparent protective shell from the stickers that are already attached to the t-shirt before moving on to printing the next layer of stickers on top· once the stickers are attached to the t-shirt with the iron they can not be rearranged or removed
MOST IMPORTANT:
· keep in mind that it is always better to use an old t-shirt and give it a new life
· there are no bad compositions!· and most importantly KEEP IT FUN :)
RECOMMENDED MATERIALS FOR PRINTING ON:
thick jersey (T-shirts with a low elastane content, hoodies, sweatshirts, raglans, sweatpants, neoprene), denim, thick cotton. Not recommended materials: textured fabrics (fleece, corduroy, velvet, knitted sweaters), very elastic materials (high elastane or biflex), quilted jackets, leather (including eco-leather), shoes, felt
CARE:
machine wash at 30 degrees on a delicate cycle or dry clean, but not earlier than 48 hours after the print has not been applied. Do not tumble dry. Iron the printed area only through a special fabric or inside out (if the inner material of the product allows it). do not bleach.
If the item is partially detached or deformed after washing (this can happen if the application parameters are not followed, intensive washing or the specific composition of the fabric), you can fix the item with an iron using the special fabric included in the set
1
To begin with take out all the cut-out elements from the envelope and arrange them so that the side with a white square sticker is facing up
2
Arrange the stickers on the t-shirt and once you achieve your desired composition take a picture of it for further reference (the recommended maximum number of layers is 3)
4
Cover the first layer of stickers with the special cloth that came with your sticker pack and gently but firmly press the iron over the stickers for 8-10 seconds. Make sure to that the steam option on your iron is off and the temperature regime is 160°C (two dots on your iron). Don't pull the iron over the cloth because that might cause the stickers to move
3
Take off all the elements that are overlapping, you will later put them back on layer by layer referencing the photo that you took (this step-by-step process is necessary due to the protective film on each sticker)
5
Make sure all the elements are properly attached and remove the protective translucent cover from the all the stickers (if the elements did not stick correctly - cover them back up with the cloth and press with the iron for another few seconds)
6
After completing the first layer, take a look at your reference photo and arrange the second layer of stickers accordingly. Repeat all the steps, remembering to remove translucent protective layer from the stickers before moving in to the next layer
7
After the whole composition is finished over it up once again with the protective close and iron everything all together one last time doing short pressing motions with the iron over entire composition
bottom of page